• RCCSE中国核心学术期刊
  • CA、AJ、JST、CSA、IC、EBSCO收录期刊
  • 中国高质量科技期刊金属材料(金属学与金属工艺)领域分级目录期刊

CPE机组缩口工艺的改进及效果

张纪明

张纪明. CPE机组缩口工艺的改进及效果[J]. 钢管, 2010, 39(2): 37-40.
引用本文: 张纪明. CPE机组缩口工艺的改进及效果[J]. 钢管, 2010, 39(2): 37-40.
Zhang Jiming. Improvement of Tube-end Pointing Process of CPE Pipe Plant and Operation Effectiveness[J]. STEEL PIPE, 2010, 39(2): 37-40.
Citation: Zhang Jiming. Improvement of Tube-end Pointing Process of CPE Pipe Plant and Operation Effectiveness[J]. STEEL PIPE, 2010, 39(2): 37-40.

CPE机组缩口工艺的改进及效果

详细信息
    作者简介:

    张纪明(1966-),男,工程师,副厂长,从事无缝钢管生产技术研究及管理工作。

  • 中图分类号: TG335.71

Improvement of Tube-end Pointing Process of CPE Pipe Plant and Operation Effectiveness

  • 摘要: CPE轧管工艺是经过改良的顶管工艺,但其仍然存在成品管长度短、金属收得率低、生产能力低等缺点。为提高该轧管工艺的成材率,武钢集团汉阳钢厂通过具体分析CPE机组缩口工艺的特点,提出了CPE机组减少金属切头损失的工艺创新思路,改进缩口工艺,实施不切“杯底”的技术措施。此技术已在该厂Φ114mmCPE机组上应用并取得良好效果。
    Abstract: Although the CPE pipe-rolling process is in fact a well-modified push bench process,it has disadvantages as rather limited length range of finished tubes,low metal yield and small production capacity,etc. Based on analysis of characteristics of the CPE plant's tube-end pointing process,some proposals are put forward by the Hanyang Steel Works,Wuhan Iron and Steel (Group) Corporation to reduce the metal loss of the plant,including improvement of the tube-end pointing process and taking non-"cup bottom"-cutting tech-nique. The innovative technology has been applied to the Φ114 mm CPE plant of the company,resulting in satisfactory effectiveness.
计量
  • 文章访问数:  11
  • HTML全文浏览量:  0
  • PDF下载量:  5
  • 被引次数: 0
出版历程
  • 修回日期:  2009-07-12
  • 网络出版日期:  2023-12-14
  • 刊出日期:  2010-04-29

目录

    /

    返回文章
    返回